Chevy Malibu and Equinox: Do They Use the Same 8-Inch MyLink Screen?

Short answer: Yes. The 2016-2025 Chevrolet Malibu and 2018-2024 Chevrolet Equinox use the same 8-inch MyLink touchscreen digitizer, referenced by GM part numbers LQ080Y5DZ06 and 84305071. The 2016-2019 Chevrolet Volt uses the identical screen as well.

Why the Malibu and Equinox Share a Screen

GM standardized its 8-inch MyLink display across several passenger cars and crossovers built in the same generation, rather than engineering a unique screen for each nameplate. The Malibu, Equinox, and Volt all launched or carried this display generation within a few years of each other, and GM reused the same digitizer, connector, and mounting hardware across all three rather than developing separate parts.

That shared engineering is why a digitizer sourced for a Malibu will also correctly fit an Equinox or Volt from the applicable model years. It is one screen platform sold under three different Chevrolet nameplates.

Verified Compatible Vehicles and Years

The following fitment is confirmed against the live Cuescreens product listing for the 8-inch MyLink digitizer:

• Chevrolet Malibu (2016-2025)
• Chevrolet Equinox (2018-2024)
• Chevrolet Volt (2016-2019)

Compatible OEM references: LQ080Y5DZ06 and 84305071.

Don't Confuse This With the Truck and SUV 8-Inch MyLink Screen

Chevrolet also uses an 8-inch MyLink and IntelliLink display across its truck and SUV lineup, including the Silverado, Tahoe, Suburban, and Colorado, along with the GMC Sierra, Yukon, Yukon XL, Canyon, and Acadia. That display is built on a different platform entirely, referenced by the part number DJ080PA-01A.

Both platforms measure 8 inches diagonally and both run MyLink or IntelliLink software, so it's an easy mix-up. But the digitizer, connector, and mounting hardware are not interchangeable between the two. If you drive a Malibu, Equinox, or Volt, you need the LQ080Y5DZ06 platform covered in this post, not the DJ080PA-01A part built for trucks and SUVs.

What "Same Screen" Actually Means

The shared component is the touchscreen digitizer, the glass touch-sensing layer mounted over the display. It is not the full LCD assembly. If your screen shows a normal image but doesn't register touches correctly, has ghost touches, freezes, or shows cracked or delaminating glass, the digitizer is the part that has usually failed, and it can be replaced without swapping the entire infotainment unit.

How to Confirm You Have the Right 8-Inch MyLink Screen

1. Confirm your vehicle and model year. Check that your Malibu, Equinox, or Volt falls within the confirmed fitment years above.
2. Verify your screen is the 8-inch MyLink system. Some trims and earlier model years used a smaller display; measure the diagonal screen size before ordering.
3. Identify the failure type. If the display image is intact but touch input is unreliable, cracked, or unresponsive, a digitizer-only replacement is the correct fix. Lines, discoloration, or a blank screen typically point to the LCD or radio itself, not the digitizer.
4. Cross-reference the part number. If your vehicle's documentation or a prior repair references LQ080Y5DZ06 or 84305071, that confirms compatibility with this digitizer. If your research turns up DJ080PA-01A instead, you have the truck and SUV platform, not this one.

Frequently Asked Questions

Does the Chevy Volt use the same 8-inch screen as the Malibu and Equinox?

Yes. The 2016-2019 Chevrolet Volt uses the same LQ080Y5DZ06 digitizer as the Malibu and Equinox.

Is this the same screen used in the Silverado or Tahoe?

No. The Silverado, Tahoe, Suburban, Colorado, and GMC truck and SUV models use a different 8-inch MyLink platform, DJ080PA-01A. It is not interchangeable with the Malibu and Equinox digitizer.

Does this replacement include the LCD display?

No. This is a digitizer-only replacement. It restores the touch-sensing glass layer while your existing LCD display stays in place.

Will this fix a blank or discolored screen?

Typically no. Symptoms like lines, discoloration, or a blank screen usually point to the LCD or radio itself rather than the digitizer, which addresses touch response and surface issues.

Do I need dealer programming after replacing the digitizer?

No. This is a direct hardware replacement and does not require dealer programming or software setup.

Bottom Line

The Malibu, Equinox, and Volt share the same 8-inch MyLink digitizer because GM built them on the same display platform, LQ080Y5DZ06. Just make sure you don't cross-shop it with the visually similar 8-inch MyLink screen used in Chevy and GMC trucks and SUVs, which is a different part entirely. You can find the 8-inch Malibu, Equinox, and Volt MyLink digitizer here, or browse the full Chevrolet touchscreen collection if your model or year falls outside this range.

About the Author: Daniel Gigante has over 18 years of experience in the automotive industry, with a focus on vehicle technology, infotainment systems, and real-world reliability. He writes about automotive design, touchscreen usability, and how modern technology impacts everyday driving.